Powers 400 Series Balancing Valves - Dial Assembly Manuel d'utilisateur télécharger pdf

1. Flush all piping thoroughly before installing.

2. Position mixer 2–1/2

″ from center line of inlets to face of

finished wall. Facing front of mixer, connect hot water to

left side, and cold water to right side. Inlet connections

must be piped correctly for proper operation of Mixer.

Connect hot water inlet to side labeled “H” on bonnet

label, or “HOT” on port label.

Single Outlet Model can be top or bottom mounted.

See Figures 1 and 2. Unit is factory assembled for top

outlet installation. For shower use only, pipe top outlet

directly to shower head. If bottom outlet is required (or

revered inlets), place mixer stem in closed position (full

clockwise) and remove O-ring and Stop (Figure 7). Rotate

stem 180° and replace Stop in its initial position. The let-

ter “C” (stamped on side of stem, Figure 3) must face the

cold water inlet when mixer is shut off. Hot and cold

inlets should also be identified to avoid confusion during

future maintenance.

4. Installation should be in accord with accepted plumbing

practices.

TECHNICAL INSTRUCTIONS

Hydroguard™ Dial Assembly

Model 6

5. Double Outlet Model. See Figure 4. The top outlet “S”

is piped to the shower head. The bottom outlet “Tub” is

piped directly to P diverter type spout, There is a built-

in diverter fitting in the Mixer so it is not necessary to

use a twin ell. Be sure that “Tub” is piped to the tub. If

the outlet connections are crossed, the Mixer will not

function properly.

6. Side Roughing-in guide onto mixer stem until it contacts

temperature stop on stem facing front of mixer, the

words “FRONT FINISHED WALL GUIDE” can be read.

Position mixer so finished wall surface will be within the

3/4

″ rim on the guide. This insures the center line of the

mixer connections will be 2-1/2 inches (64 mm) from the

finished wall surface. After wall is finished, remove guide.

Form TI401

1 2

TECHNICAL INSTRUCTIONS 1

Résumé du contenu

Page 1 - TECHNICAL INSTRUCTIONS

1. Flush all piping thoroughly before installing.2. Position mixer 2–1/2″ from center line of inlets to face offinished wall. Facing front of mixer, c

Page 2

TI401 Page 2Reprinted © April 2001 Powers, a Watts Industries Co.3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.67

Commentaires sur ces manuels

Pas de commentaire

Powers 400 Series Balancing Valves - Dial Assembly Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour l'eau Powers 400 Series Balancing Valves - Dial Assembly. Powers 400 Series Balancing Valves - Dial Assembly User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour l'eau Powers 400 Series Balancing Valves - Dial Assembly